ESP8266 WiFi microcontroller board

EVO779

New product

This board integrates the last version of the very popular ESP8266 WiFi module. More than a simple WiFi module, this ESP-12E version is a real microcontroller with GPIOs, SPI and of course embedded WiFi. Easy to use with the Arduino IDE, CE and FCC certified, it's the perfect companion for your next IOT projects.

More details

This product is no longer in stock

share

No reward points for this product.


9,96 € tax incl.

Add to wishlist

More info

STARTER GUIDE

Technical description:

WiFi:

WiFi 2.4 GHz 802.11 b/g/n
Support WPA/WPA2
Integrated TCP/IP protocol stack with DNS support
Can be used as a WiFi client or access point

Processor:

Integrated 80MHz low power 32-bit MCU with
10-bit ADC pin
4MB flash (exposed pins for programming)
9 GPIOs - GPIO 0 is used for programming, GPIO2 is wired to 3.3v and GPIO15 wired to Gnd to enable the module at startup. You should avoid using this pins but if you need it, you must cut the jumper trace at the back of the PCB and use pull up resistors.
UART TX-RX pins
Deep sleep power mode
RESET button
Power: 3 ~ 3.6V (3.3V regulated on this board) - 80mA

Power:

DC Jack input: 5V ~ 12V
3.3V output: 1.2A max
Onboard Power Led

Programming:

To program the ESP8266 board the chip needs to be in Flash mode. To do this, press the FLASH button, then press the RESET button while keeping the FLASH button pressed. Release the RESET button, then release the FLASH button.
You can use the Arduino IDE to program the ESP8266 board with the Arduino language. Download the latest version of the Arduino IDE (1.6.4 or more recent) and add this link into the Additional Board Manager URLs field in the Arduino preferences.


Operating temperature range -40°C ~ 125°C
FCC, CE, TELEC, WiFi Alliance and SRRC certified

Weight: 10g
Dimensions: 30x60mm

Assembled in France

Accessories

6 other products in the same category:

Customers who bought this product also bought:

Download